生活中經常能遇到電動卷簾門，有些人對電動卷簾門不是很了解，甚不知道如何調制，操作起來很不方便。下面針對問題，濟南卷簾門廠家給您建議：

We often encounter electric roller shutter doors in our life. Some people don't know much about electric roller shutter doors, or even how to adjust them. It is very inconvenient to operate. The following suggestions are given to you by Jinan roller shutter manufacturer:

如何調控電動卷簾門？

How to control the electric roller shutter door?

在排除故障之前，需要松開界上的螺絲，不要太緊，然后拉起環鏈，使環鏈與地面保持一米的距離。

Before troubleshooting, it is necessary to loosen the screws on the boundary, not too tight, and then pull up the chain to keep the chain one meter away from the ground.

用手按遙控器上面的按鈕，檢查卷簾門的升降功能是否正常，有沒有問題。

Press the button on the remote control manually to check whether the lifting function of the roller shutter door is normal and whether there is any problem.

如果卷簾門所有功能正常，將門簾升所需高度，轉動螺套，調整觸摸系統微動開關的滑輪，發出滴答聲后擰緊螺絲。

If all functions of the roller shutter door are normal, raise the door curtain to the required height, turn the screw sleeve, adjust the pulley of the touch system microswitch, and tighten the screw after clicking.

后，將故障來回排除，完全沒有問題后，就可以正常使用卷簾了。

After that, remove the fault back and forth. After there is no problem at all, you can use the roller shutter normally.

在實際使用卷簾的過程中，經常發生沒有電源的情況，怎么辦？

During the actual use of the roller shutter, there is often no power supply. What should I do?

如果出現短時間無電的情況，則暫時不用理會，待來電后再可使用卷簾。

If there is no power for a short time, you can ignore it temporarily and use the shutter after the call.

如果卷簾本身有應急電源，即使出現停電，也可以正常打開，不會有任何問題。

If the shutter itself has emergency power supply, it can be opened normally even in case of power failure, without any problems.

如果卷簾門沒有應急電源，可以用手拉動手搖器，然后拉開檢修孔，此時可以輕松打開卷簾門。

If there is no emergency power supply for the shutter door, you can pull the hand crank by hand, and then open the access hole. At this time, you can easily open the shutter door.

總的來說，電動卷簾門的故障排除方法一點都不復雜。只要你掌握正確的方法，就可以使卷簾門正常工作而不出現任何問題。更多相關內容就來我們網站http://m.emamhasanmojtaba.com咨詢吧！

In general, the troubleshooting method of electric roller shutter door is not complicated at all. As long as you master the correct method, you can make the roller shutter work normally without any problems. Come to our website for more relevant content http://m.emamhasanmojtaba.com Ask!